IEC61970::Base::Wires::Cut Class Reference

#include <Cut.h>

Inheritance diagram for IEC61970::Base::Wires::Cut:

Collaboration diagram for IEC61970::Base::Wires::Cut:

Public Attributes
IEC61970::Base::Domain::Length	lengthFromTerminal1
IEC61970::Base::Wires::ACLineSegment *	ACLineSegment
Public Attributes inherited from IEC61970::Base::Wires::Switch
IEC61970::Base::Domain::Boolean	normalOpen
IEC61970::Base::Domain::Boolean	open
IEC61970::Base::Domain::CurrentFlow	ratedCurrent
IEC61970::Base::Domain::Boolean	retained
IEC61970::Base::Domain::Integer	switchOnCount
IEC61970::Base::Domain::DateTime	switchOnDate
std::list< IEC61970::Base::Wires::SwitchPhase * >	SwitchPhase
std::list< IEC61970::Base::Wires::SwitchSchedule * >	SwitchSchedules
Public Attributes inherited from IEC61970::Base::Core::Equipment
IEC61970::Base::Domain::Boolean	aggregate
IEC61970::Base::Domain::Boolean	normallyInService
Public Attributes inherited from IEC61970::Base::Core::PowerSystemResource
std::list< IEC61970::Base::Meas::Control * >	Controls
std::list< IEC61970::Base::Meas::Measurement * >	Measurements
IEC61970::Base::Core::PSRType *	PSRType
Public Attributes inherited from IEC61970::Base::Core::IdentifiedObject
IEC61970::Base::Domain::String	aliasName
IEC61970::Base::Domain::String	description
IEC61970::Base::Domain::String	mRID
IEC61970::Base::Domain::String	name
std::list< IEC61970::Base::DiagramLayout::DiagramObject * >	DiagramObjects

Detailed Description

A cut separates a line segment into two parts. The cut appears as a switch inserted between these two parts and connects them together. As the cut is normally open there is no galvanic connection between the two line segment parts. But it is possible to close the cut to get galvanic connection. The cut terminals are oriented towards the line segment terminals with the same sequence number. Hence the cut terminal with sequence number equal to 1 is oriented to the line segment's terminal with sequence number equal to 1. The cut terminals also act as connection points for jumpers and other equipment, e.g. a mobile generator. To enable this, connectivity nodes are placed at the cut terminals. Once the connectivity nodes are in place any conducting equipment can be connected at them.

Member Data Documentation

IEC61970::Base::Wires::ACLineSegment* IEC61970::Base::Wires::Cut::ACLineSegment

The line segment to which the cut is applied.

IEC61970::Base::Domain::Length IEC61970::Base::Wires::Cut::lengthFromTerminal1

The length to the place where the cut is located starting from side one of the cut line segment, i.e. the line segment Terminal with sequenceNumber equal to 1.

---

The documentation for this class was generated from the following files:

• IEC61970/Base/Wires/Cut.h
• IEC61970/Base/Wires/Cut.cpp