CIM++ Adapted CIM Codebase
Public Attributes | List of all members
IEC61970::Base::Wires::Cut Class Reference

#include <Cut.h>

Inheritance diagram for IEC61970::Base::Wires::Cut:
Inheritance graph
Collaboration diagram for IEC61970::Base::Wires::Cut:
Collaboration graph

Public Attributes

IEC61970::Base::Domain::Length lengthFromTerminal1
- Public Attributes inherited from IEC61970::Base::Wires::Switch
IEC61970::Base::Domain::Boolean normalOpen
IEC61970::Base::Domain::Boolean open
IEC61970::Base::Domain::CurrentFlow ratedCurrent
IEC61970::Base::Domain::Boolean retained
IEC61970::Base::Domain::Integer switchOnCount
IEC61970::Base::Domain::DateTime switchOnDate
std::list< IEC61970::Base::Wires::SwitchPhase * > SwitchPhase
std::list< IEC61970::Base::Wires::SwitchSchedule * > SwitchSchedules
- Public Attributes inherited from IEC61970::Base::Core::Equipment
IEC61970::Base::Domain::Boolean aggregate
IEC61970::Base::Domain::Boolean normallyInService
- Public Attributes inherited from IEC61970::Base::Core::PowerSystemResource
std::list< IEC61970::Base::Meas::Control * > Controls
std::list< IEC61970::Base::Meas::Measurement * > Measurements
- Public Attributes inherited from IEC61970::Base::Core::IdentifiedObject
IEC61970::Base::Domain::String aliasName
IEC61970::Base::Domain::String description
IEC61970::Base::Domain::String mRID
IEC61970::Base::Domain::String name
std::list< IEC61970::Base::DiagramLayout::DiagramObject * > DiagramObjects

Detailed Description

A cut separates a line segment into two parts. The cut appears as a switch inserted between these two parts and connects them together. As the cut is normally open there is no galvanic connection between the two line segment parts. But it is possible to close the cut to get galvanic connection. The cut terminals are oriented towards the line segment terminals with the same sequence number. Hence the cut terminal with sequence number equal to 1 is oriented to the line segment's terminal with sequence number equal to 1. The cut terminals also act as connection points for jumpers and other equipment, e.g. a mobile generator. To enable this, connectivity nodes are placed at the cut terminals. Once the connectivity nodes are in place any conducting equipment can be connected at them.

Member Data Documentation

◆ ACLineSegment

IEC61970::Base::Wires::ACLineSegment* IEC61970::Base::Wires::Cut::ACLineSegment

The line segment to which the cut is applied.

◆ lengthFromTerminal1

IEC61970::Base::Domain::Length IEC61970::Base::Wires::Cut::lengthFromTerminal1

The length to the place where the cut is located starting from side one of the cut line segment, i.e. the line segment Terminal with sequenceNumber equal to 1.

The documentation for this class was generated from the following files: